Section I General Safe Work Practices
1: Introduction to Electrical Safe Work Practices
2: Planning and Communication
3: Ethics and Professionalism
4: Electrical Hazards
5: Exposure Management
6: Protecting the Person
7: The Electrical Safety Program
8: Introduction to Electrical Standards
9: Human Behaviors
10: Recognizing Unsafe Installations
11: Preparing for Incidents and Injuries
12: Safety by Design
Section II Specific Work Practices
13: Conducting a Job Briefing
14: Performing Repetitive Tasks
15: Using Lockout/Tagout
16: Coordinating Work with Other Contractors (Blue Tag-Green Tag)
17: Authorizing Tasks
18: Selecting and Using Voltmeters
19: Testing for Absence of Voltage
20: Recognizing the Importance of Body Position
21: Using Insulated and Insulating Tools
22: Using Warnings Against Hazards
23: Installing and Removing Temporary Safety Grounds
24: Grounding Line Trucks, Cranes, and Lifting Devices
25: Installing Necessary Lighting
26: Avoiding Blind Reaching
27: Maintaining Alertness
28: Handling Conductive Material
29: Using Mobile Equipment
30: Performing Routine Housekeeping and Maintenance
31: Performing Housekeeping in Classified Hazardous Locations
32: Using Flammable Materials
33: Recognizing Impending Failure
34: Operating Switches Routinely
35: Selecting and Using PPE
36: Relying on Approach Distances
37: Caring for Voltmeters
38: Using Portable Ladders
39: Avoiding the Use of Conductive Apparel
40: Respecting Interlock
41: Closing Doors and Replacing Covers
42: Closing Holes in Equipment
43: Drilling into Enclosures and Using Knockout Punches
44: Working in Confined Spaces
45: Marking and Labeling
46: Using Hazard/Risk Analysis
47: Opening and Closing Circuits Routinely
48: Reclosing Circuits After Protective Device Operation
49: Caring for PPE
50: Checking and Replacing Fuses